- Atsiimkite Vilniuje šiandien
![](https://eskimas.lt/172425-large_default/.jpg)
The principle of operation of the 3D pen is very simple. Unlike conventional writing or drawing tools, plastic is used instead of graphite. There is a special opening in the rear part of the case, into which the plastic fits. A built-in mechanism automatically feeds the plastic to a heater, where it melts and squeezes out as an alloy. The tip of the print head heats up to 230 °С, so it is necessary to observe all safety requirements when using the device. The dimensions of the device will allow you to comfortably hold it in one hand. The slight noise of the built-in mechanism does not distract from 3D modeling while working with the pen.
Specifications:
Color: yellow
In the set: pen, usb cable, stand, x3 colors, instructions